Drive Shaft Spacer Type 3 Custom For Lower Left 5m Belt Shaft Sprocket when using 2 left side shaft bearings only! Some models/frames only benefit from extra left side bearing when primary bearing fails or shaft is worn where bearing rides.most models can carry 2 left bearings. call if need be. Fits many scooters if driveshaft bearing dwell in frame is exact same size for entire bore & is for custom improved application or temp fix only! not stock! This spacer goes outside or between lower left side drive shaft bearings x 2! If between two left bearings on Cobra you may need a washer or change pulley to our solid metal lower left pulley. This is for custom application only. Call before ordering! This spacer is only used when installing 2 left side bearings for which some frames don't retain the 2nd left side bearing. Call and we will explain. (256)468-2761 This is an improved spacer that is made in usa. Specs:ID-480/1000ths, OD-750/1000ths, 340-350 thousandths long.

Drive Shaft Spacer Type 4 Custom For Lower Left 5m Belt Shaft Sprocket when using 2 left side shaft bearings only! Some models/frames only benefit from extra left side bearing when primary bearing fails. most models can carry 2 left bearings. call if need be. Fits many scooters if driveshaft bearing dwellin frame is exact same size for entire bore & is for custom improved application only! not stock! This spacer goes between lower left side pulley and left side drive shaft bearings x 2! Or between two left bearings on Cobra. This is for custom application only. Call before ordering! This spacer is only used when installing 2 left side bearings for which some frames don't retain the 2nd left side bearing. Call and we will explain. 256.468.2761 This is an improved spacer that is made in usa. Specs:ID-480/1000ths, OD-750/1000ths, 400 thousandths long. use of type 3 spacer for this extra bearing setup is more common.

Driveshaft Spacer Type 5 goes Between Right Bearing & small gear to keep sprocket from walking or rubbing inside of frame. Specs-ID-600/1000ths OD-800/1000ths & is 200/1000ths wide. need for such a spacer to be determined by purchaser by measuring distance between edge of installed gear & right side bearing. not all shafts need such a spacer as some have gear snap ring like Cobra or can be welded. not for use with chain drive kits.

Drive Shaft With Hardened 20 tooth Belt Gear installed for Cobra & The Rock & Nuke & StandR & Lowrider Rock only!

Eton 41.5cc Rubber Engine Mounts for scooters Set Of 2

Eton 40 Piston Wrist Pin p/n 650116

Eton Engine Mount Plate Engine and muffler bolts to it. Repace broken plate to reduce noise and vibration and improve belt alignment. For scooter only

Eton 41.5cc Exhaust Gasket p/n 700146 Replace this gasket every time exhaust is removed.

Eton scooter exhaust OEM does not include exhaust gasket. The gasket must be ordered separately.

Set of 6. Or upgrade to oversized stainless with washers & nuts

Factory Swingarm For Rear Suspension. For models using tire drive belt size lengths 670 to 740. Excludes big wheel & models with disc brakes, But is intended for use with band brakes. Sold as a pair.

Fender Front Chromed keep water and mud down with a classic stylish oversized Chrome front fender, fits MANY different scooters with 10 inch tires