Driveshaft Spacer Type 5 goes Between Right Bearing & small gear to keep sprocket from walking or rubbing inside of frame. Specs-ID-600/1000ths OD-800/1000ths & is 200/1000ths wide. need for such a spacer to be determined by purchaser by measuring distance between edge of installed gear & right side bearing. not all shafts need such a spacer as some have gear snap ring like Cobra or can be welded. not for use with chain drive kits.

Driveshaft Spacer Type 6 goes Between Right Bearing & small gear to keep sprocket from walking or rubbing inside of frame. Specs-ID-600/1000ths OD-800/1000ths & is 120/1000ths wide. need for such a spacer to be determined by purchaser by measuring distance between edge of installed gear & right side bearing. not all shafts need such a spacer as some have gear snap ring like Cobra or can be welded. not for use with chain drive kits.

Drive Shaft With Hardened 20 tooth Belt Gear installed for Cobra & The Rock & Nuke & StandR & Lowrider Rock only!

ETON 40/41.5cc plastic engine cover P/N 700151

Engine crankcase and crankshaft with cylinder head and piston and spark plug & exhaust studs or bolts & gasket & intake gasket only. does not include carburetor, starter recoil or catch/ratchet or clutch shoes or flywheel or ignition coils,engine covers, external engine parts sold separately.

1 x crankcase gasket 2 x crankshaft bearings 2 x crankshaft seals

Eton 41.5cc Rubber Engine Mounts for scooters Set Of 2

Eton IXL 40 e-ton rxl 40 & 40E Engine Top End Rebuild Kit. P/n 810788 Includes cylinder head and cylinder gasket and exhaust gasket and piston and piston rings and piston wrist pin and needle bearing and circle clips and NGK BPM6A spark plug. Air and fuel intake parts separate.

Eton 40 ATV float style carb Performance jet. Factory jet in new style carburetor is a number 64 which you may find as insufficient Jetting so we offer a number 77 jet for replacement for anybody who has running issues or fuel supply issues with the new style carburetor with quick drain bowl valve and petcock made on the carburetor we do not sell any parts or jets for the original carburetor that does not have those two features.

Eton 40 Billet CNC Start Receiver 700168-CNC

Eton 40 Coil Mount Bolt Set of two bolts with 7mm head for easy coil adjustment on Black Thunder Coils These are the OEM coil mount bolts used on the green coil from factory

Eton 40 Ikeda Coil Harness This wiring harness replaces the trigger module when using the New Black Thunder coil, the wiring harness plugs onto the new ignition coil and then plugs right into the vehicle harness with two wires in a 3-pin plug. If you are purchasing the coil the coil will come with this wiring harness and an NGK spark plug so there would be no need to purchase this harness if you are purchasing the coil it is included.