Crankshaft Seal 41.5cc L.H. Flywheel/Magneto side 12x32x7 p/n 700292

Eton 41.5cc Crankseal Rightside behind pullstart reciever 12x22x7 p/n 700291

Crankshaft Seals Set left and right side seals

Eton 41.5cc Cylinder Head Gasket p/n. 700122

Eton 41.5cc Cylinder Head p/n 700121

Disc brake loaded caliper For The Rocky & Cobra Extreme Fits front or rear. 52 mm bolt spacing. New and improved fully adjustable Made in Taiwan by Cobra

Scooter gear Hardened 20 tooth Metal 5M Belt Gear Same size as factory small metal belt gear on transmission. This is the factory small metal gear for "the rock", this is the recommended belt gear for shaft as it is Hardened and wears slowly. Replace your worn out sprocket today and break less belts.

Drive Shaft Bearing #6201 SALE $8.60 each

Drive Shaft Bearing Snap Ring for Cobra, the Rock, Rockette, Dynamite III, Nuke, Lowrider Rock, StandR, commuter Holds shaft bearings in place.

Drive Shaft Big Sprocket 4mm "Keybar" keeps lower left side bigger pulley from spinning on shaft

Stainless Steel Driveshaft Nut

Drive Shaft Spacer Type 3 Custom For Lower Left 5m Belt Shaft Sprocket when using 2 left side shaft bearings only! Some models/frames only benefit from extra left side bearing when primary bearing fails or shaft is worn where bearing rides.most models can carry 2 left bearings. call if need be. Fits many scooters if driveshaft bearing dwell in frame is exact same size for entire bore & is for custom improved application or temp fix only! not stock! This spacer goes outside or between lower left side drive shaft bearings x 2! If between two left bearings on Cobra you may need a washer or change pulley to our solid metal lower left pulley. This is for custom application only. Call before ordering! This spacer is only used when installing 2 left side bearings for which some frames don't retain the 2nd left side bearing. Call and we will explain. (256)468-2761 This is an improved spacer that is made in usa. Specs:ID-480/1000ths, OD-750/1000ths, 340-350 thousandths long.