Driveshaft Spacer Type 5 goes Between Right Bearing & small gear to keep sprocket from walking or rubbing inside of frame. Specs-ID-600/1000ths OD-800/1000ths & is 200/1000ths wide. need for such a spacer to be determined by purchaser by measuring distance between edge of installed gear & right side bearing. not all shafts need such a spacer as some have gear snap ring like Cobra or can be welded. not for use with chain drive kits.

Driveshaft Spacer Type 6 goes Between Right Bearing & small gear to keep sprocket from walking or rubbing inside of frame. Specs-ID-600/1000ths OD-800/1000ths & is 120/1000ths wide. need for such a spacer to be determined by purchaser by measuring distance between edge of installed gear & right side bearing. not all shafts need such a spacer as some have gear snap ring like Cobra or can be welded. not for use with chain drive kits.

ETON 40/41.5cc plastic engine cover P/N 700151

1 x crankcase gasket 2 x crankshaft bearings 2 x crankshaft seals

Eton 41.5cc Rubber Engine Mounts for scooters Set Of 2

Eton 40 Coil Mount Bolt Set of two bolts with 7mm head for easy coil adjustment on Black Thunder Coils These are the OEM coil mount bolts used on the green coil from factory

Eton 40 Ikeda Coil Harness This wiring harness replaces the trigger module when using the New Black Thunder coil, the wiring harness plugs onto the new ignition coil and then plugs right into the vehicle harness with two wires in a 3-pin plug. If you are purchasing the coil the coil will come with this wiring harness and an NGK spark plug so there would be no need to purchase this harness if you are purchasing the coil it is included.

Eton 40 Piston Wrist Pin p/n 650116

Eton Engine Mount Plate Engine and muffler bolts to it. Repace broken plate to reduce noise and vibration and improve belt alignment. For scooter only

Eton 41.5cc Exhaust Gasket p/n 700146 Replace this gasket every time exhaust is removed.

Eton scooter exhaust OEM does not include exhaust gasket. The gasket must be ordered separately.

eton 40 exhaust studs $2.00ea order two for a pair We now use a allen drive cap head bolt with integrated washers instead of factory exhaust stud. Reccomend Red locktite on exhaust bolts.