Eton 40 Billet CNC Start Receiver 700168-CNC

Eton 40 Coil Mount Bolt Set of two bolts with 7mm head for easy coil adjustment on Black Thunder Coils These are the OEM coil mount bolts used on the green coil from factory

Eton 40 Ikeda Coil Harness This wiring harness replaces the trigger module when using the New Black Thunder coil, the wiring harness plugs onto the new ignition coil and then plugs right into the vehicle harness with two wires in a 3-pin plug. If you are purchasing the coil the coil will come with this wiring harness and an NGK spark plug so there would be no need to purchase this harness if you are purchasing the coil it is included.

Eton 40 Piston Wrist Pin p/n 650116

Eton 41.5cc 2.2hp Engine Rebuild Kit Comes with piston and rings and needle bearing and wrist pin and gclips and cylinder head/jug and cylinder gasket and crankshaft seals and and bearings and crankcase gasket and crankshaft and crank keyway and nuts and spark plug. basically it is all the parts that comprise the engine except for the two crankcase halves if you need crankcase halves order them separately

Eton Engine Mount Plate Engine and muffler bolts to it. Repace broken plate to reduce noise and vibration and improve belt alignment. For scooter only

Eton 41.5cc Exhaust Gasket p/n 700146 Replace this gasket every time exhaust is removed.

Eton scooter exhaust OEM does not include exhaust gasket. The gasket must be ordered separately.

eton 40 exhaust studs $2.00ea order two for a pair We now use a allen drive cap head bolt with integrated washers instead of factory exhaust stud. Reccomend Red locktite on exhaust bolts.

Set of 6. Or upgrade to oversized stainless with washers & nuts

Fender Front Chromed keep water and mud down with a classic stylish oversized Chrome front fender, fits MANY different scooters with 10 inch tires

5m stainless steel button head allen drive deck screws with stainless washers and lock washers. A must for aftermarket footboards or stripped out factory holes in box frame. For the Rocky & Cobra Extreme the screw Holes in frame will have to be drilled and then tapped to a metric thread pitch of .80