Drive Shaft Bearing #6201 SALE $8.60 each

Drive Shaft Bearing Snap Ring for Cobra, the Rock, Rockette, Dynamite III, Nuke, Lowrider Rock, StandR, commuter Holds shaft bearings in place.

Cobra or The Rock or Lowrider Rock, Nuke or StandR or Cobra "commuter" Driveshaft ONLY note: order 20t-5m & 60t-5m sprockets and spacer & bearings & 4mm keybar or snap rings separately

Drive Shaft made per order fits ScootR, Salorr, Staru, R3, Tiger, Rockfield, Libra T.H.S. & chuweng & Raser, FX. R1, R3, R4, R5 Use correct "pulley spacer" intended for use with one or two left side bearings between left side shaft pulley and bearing s? to avoid major shaft damage. Call scooterman @ 256.468.2761 & inspect frame to determine correct application of one or two left side bearings.

Drive Shaft Big Sprocket 4mm "Keybar" keeps lower left side bigger pulley from spinning on shaft

Stainless Steel Driveshaft Nut

Drive Shaft Spacer Type 3 Custom For Lower Left 5m Belt Shaft Sprocket when using 2 left side shaft bearings only! Some models/frames only benefit from extra left side bearing when primary bearing fails or shaft is worn where bearing rides.most models can carry 2 left bearings. call if need be. Fits many scooters if driveshaft bearing dwell in frame is exact same size for entire bore & is for custom improved application or temp fix only! not stock! This spacer goes outside or between lower left side drive shaft bearings x 2! If between two left bearings on Cobra you may need a washer or change pulley to our solid metal lower left pulley. This is for custom application only. Call before ordering! This spacer is only used when installing 2 left side bearings for which some frames don't retain the 2nd left side bearing. Call and we will explain. (256)468-2761 This is an improved spacer that is made in usa. Specs:ID-480/1000ths, OD-750/1000ths, 340-350 thousandths long.

Drive Shaft With Hardened 20 tooth Belt Gear installed for Cobra & The Rock & Nuke & StandR & Lowrider Rock only!

Eton 41.5cc Rubber Engine Mounts for scooters Set Of 2

Eton 40 ATV or older scooter Air Filter High Performance for Float Style Carbs. Comes with filter and filter clamp and velocity stack and gasket and two screws.

Eton 40 Ikeda Coil Harness This wiring harness replaces the trigger module when using the New Black Thunder coil, the wiring harness plugs onto the new ignition coil and then plugs right into the vehicle harness with two wires in a 3-pin plug. If you are purchasing the coil the coil will come with this wiring harness and an NGK spark plug so there would be no need to purchase this harness if you are purchasing the coil it is included.

Factory Swingarm For Rear Suspension. For models using tire drive belt size lengths 670 to 740. Excludes big wheel & models with disc brakes, But is intended for use with band brakes. Sold as a pair.