Scooter gear Hardened 20 tooth Metal 5M Belt Gear Same size as factory small metal belt gear on transmission. This is the factory small metal gear for "the rock", this is the recommended belt gear for shaft as it is Hardened and wears slowly. Replace your worn out sprocket today and break less belts.

Drive Shaft Spacer Type 4 Custom For Lower Left 5m Belt Shaft Sprocket when using 2 left side shaft bearings only! Some models/frames only benefit from extra left side bearing when primary bearing fails. most models can carry 2 left bearings. call if need be. Fits many scooters if driveshaft bearing dwellin frame is exact same size for entire bore & is for custom improved application only! not stock! This spacer goes between lower left side pulley and left side drive shaft bearings x 2! Or between two left bearings on Cobra. This is for custom application only. Call before ordering! This spacer is only used when installing 2 left side bearings for which some frames don't retain the 2nd left side bearing. Call and we will explain. 256.468.2761 This is an improved spacer that is made in usa. Specs:ID-480/1000ths, OD-750/1000ths, 400 thousandths long. use of type 3 spacer for this extra bearing setup is more common.

ETON 40/41.5cc plastic engine cover P/N 700151

Engine crankcase and crankshaft with cylinder head and piston and spark plug & exhaust studs or bolts & gasket & intake gasket only. does not include carburetor, starter recoil or catch/ratchet or clutch shoes or flywheel or ignition coils,engine covers, external engine parts sold separately.

1 x crankcase gasket 2 x crankshaft bearings 2 x crankshaft seals

Eton 41.5cc Rubber Engine Mounts for scooters Set Of 2

Eton 40 Billet CNC Start Receiver 700168-CNC

Eton 40 Ikeda Coil Harness This wiring harness replaces the trigger module when using the New Black Thunder coil, the wiring harness plugs onto the new ignition coil and then plugs right into the vehicle harness with two wires in a 3-pin plug. If you are purchasing the coil the coil will come with this wiring harness and an NGK spark plug so there would be no need to purchase this harness if you are purchasing the coil it is included.

Eton 41.5cc 2.2hp Engine Rebuild Kit Comes with piston and rings and needle bearing and wrist pin and gclips and cylinder head/jug and cylinder gasket and crankshaft seals and and bearings and crankcase gasket and crankshaft and crank keyway and nuts and spark plug. basically it is all the parts that comprise the engine except for the two crankcase halves if you need crankcase halves order them separately

Eton Engine Mount Plate Engine and muffler bolts to it. Repace broken plate to reduce noise and vibration and improve belt alignment. For scooter only

Eton 41.5cc Exhaust Gasket p/n 700146 Replace this gasket every time exhaust is removed.

Eton scooter exhaust OEM does not include exhaust gasket. The gasket must be ordered separately.